Converting Brewster Homes from Electric to Propane Appliances

Planning a Switch Before the First Pipe Goes In

The most common mistake in a fuel switch is piping for today's single appliance and ignoring tomorrow's. A homeowner adds a propane furnace, and two years later wants a gas range and a tankless water heater. If the first line was sized only for the furnace, the later additions mean tearing into walls again or living with weak burners.

We start by asking what you want now and what you might add later. Then we size the main trunk for the eventual load and leave capped tees where future branches will go. It costs little extra on day one and saves a lot of disruption later.

• Furnace or boiler conversions from oil or electric
• Gas ranges and cooktops replacing electric units
• Dryer hookups in basement or first-floor laundry rooms
• Tank or tankless water heaters
• Fireplace inserts and vent-free heaters

Choosing the Entry Point and Route

Your propane supplier will help pick a tank location that meets their setback rules and allows a delivery truck to reach it. From there, we look for the shortest practical path to the house and a good spot for the second-stage regulator, ideally on a wall where snow will not slide off the roof onto it.

Inside, older farmhouses and village homes around Brewster often have stone or block basements with limited open joist space. We route black iron along beams where it is protected and accessible, and use flexible CSST where we need to snake through finished areas to reach a kitchen or upstairs fireplace.

Converting Appliances the Right Way

Many gas appliances ship set up for natural gas. Before they can burn propane, they need the manufacturer's LP conversion kit, which usually swaps burner orifices and adjusts or replaces the appliance regulator. We install those parts, connect the appliance with a proper shutoff and connector, and check the flame after the gas is on.

Appliances you already own can sometimes be converted as well, as long as the manufacturer offers a kit. If you are buying new, ask for the propane version or the conversion kit at purchase. It saves time on installation day.

What a Typical Conversion Day Looks Like

Once you approve the plan, we coordinate with the supplier so the tank and first-stage regulator are set. We install the yard line, second-stage regulator, interior piping and appliance branches, then pressure test the whole system with the appliances isolated. After the supplier brings the tank into service, we light each appliance, confirm good combustion, and walk you through the shutoffs.

Removing old oil tanks or capping electric circuits falls to other trades, and we are happy to point you in the right direction for that part of the job.

Repairs for Existing Brewster Propane Systems

Not every call is a conversion. We also repair propane systems that have been in service for years: replacing corroded regulators, fixing leaking unions, replacing old copper connectors, and tracking down underground losses. If your home has well water and a propane water heater, our Brewster gas water heater service can handle both the appliance and the gas side together.

Cooking upgrades are another common project, and we can set up a propane cooktop in Brewster with the right orifices from the start. For a countywide view of how we plan LP piping, see our propane line installation and repair page.