Getting Your Macedonia Project Ready for New Plumbing

Before the Estimate

A free estimate is more accurate when we can see the whole picture. Gather what you have, even if it is rough:

• Floor plans or a sketch with fixture locations marked
• Fixture selections, or at least the type of tub, shower and toilet you want
• Access to the basement, crawlspace or utility room where the water service and main drain are
• Any permit paperwork or builder schedule already in place
• A list of extras you are considering, such as a wet bar, laundry sink or outdoor spigot

Why fixture choices matter so early

A freestanding tub, a wall-hung toilet or a shower with multiple body sprays changes where drains go and what size lines are needed. If those decisions are still open, we will rough in for the most likely option and tell you what would change if you choose differently.

Before Underground Work

If drains need to go under a slab or basement floor, that work happens before concrete. The area should be excavated or open to the gravel base, with forms set if it is a new pour. The location of interior walls should be marked on the ground so we place stubs in the right spots. Clear access for equipment and a spot to stage pipe help the day run smoothly. Once the underground lines are in and tested, the inspection has to pass before anyone covers them.

Before Rough-In

Rough-in can begin when framing is complete and the structure is closed in against weather. A rough-in visit that runs into missing walls, an open roof or an unfinished floor system usually means a second trip.

Specifically, check that:

• All walls that hold plumbing are framed, including blocking for wall-hung fixtures
• Cabinets, vanities and appliance locations are marked on the floor or studs
• Heating ductwork routes are known, since ducts and drains often compete for the same joist bays
• Any tub or shower base that must be set before framing is on site
• Power is available for tools and test equipment

Before Inspections

For rough-in inspections, walls, floors and ceilings must stay open until the inspector has signed off. Do not let insulation or drywall crews start early. The system will be under test when the inspector arrives, so the water or air test needs to be left alone. For the final inspection, fixtures should be installed and operational, with access to cleanouts and shutoffs.

If an older home's existing plumbing fails an inspection during the project, our code violation repair service can correct it.

Before Trim-Out and the Final Visit

We set fixtures after drywall, paint, flooring, cabinets and countertops are in. Having all fixtures, faucets and trim kits on site, still boxed and checked for damage, lets us complete the trim-out in one visit. You do not need to be home the whole time, but someone should be available at the start and end of the day to answer questions and see the finished work.

For builder-led projects, see our construction plumbing page. For details on materials and stages, visit the new plumbing installation overview.